ToolBox High Tack

Categories: Silicone

Toolbox High Tack is a one-part, high modulus hybrid adhesive with superior wet-grab strength.

Toolbox High tack is a one=part, high modulus hybrid adhesive with superior wet-grab strength that makes it ideally suited to bonding heavy objects such as metal signs to vertical surfaces. Toolbox High Tack also exhibits superior grab in overhead applications, making is especially suitable for bonding various ceiling components. In addition, Toolbox High tack provides an efficient seal when compressed between substrates. Toolbox High Tack is considered non-hazardous according to GHS regulations.

Key Benefits

Isocyante free
Non-hazardous
Free of phthalate plasticisers
Cures to form a strong bond
Rapid skinning and curing
Non-corrosive -does not attack substrates
High viscosity – excellent green strength
No shrinkage
Very low odour
Permanently flexible in temperatures between -40°C and +100°C
Paintable wet on wet with waterbased paints
Resistant to water, dilute alkalis, cleaning agents, lime water and mould

Substrates

Glass
Timber
Rubbers
Fibre Cement
Concrete
Plastics (pre-test)
Fibreglass
Plasterboard
Steel
Aluminium
Masonry

*Not suitable a a joint sealant or adhesive for a permanent immersion in chlorinated water
*Not suitable for glazing
*Not suitable for joints required to accommodate a large amount of movement

Colours

White

Uses

Bonding metal signs used in sign-writing
Automotive assembly, including caravan construction
General assembly where a high level of bond strength and vibration resistance is required
Applications where a very high level of green bond strength is required
Installation of ceiling components, including soffit and other composite panels used in shop fit-out

How To Use

Cut tip off cartridge. Screw nozzle on to cartridge. Apply to one surface to be bonded with the cartridge verical above the surface having the adhesive applied to it.
Before product skins, mate with other surface.When bonding sheet or panel to a large flat surface, apply beads every 30-40cm along the entire length. Press into position and brace until set if required.
Bond will develop dependent upon thickness of adhesive and ambient conditions. Higher humidity and warmer temperatures will hasten bond development. Minimum film thickness for bonding applications is approx. 2mm. Where a perimeter seal is required apply sufficient Toolbox High Tack relatively close to the edge of the substrate being bonded, so that the adhesive squeezes out to fill the gap between the mated materials. Tool off any excess with a spatula before Toolbox high tack skins.
Toolbox High tack should be applied between 5°C and 35°C. Ensure that the substrates are clean and dry when Toolbox High tack is applied and do not apply where conditions may interfere with good bonding/sealing eg do not apply if frost or ice is present.

There are currently no colour options available for this product.

There are currently no downloads available for this product.

Why Choose HMR Supplies?

Have a question or need assistance finding a product?

METAL ROOFING PRODUCTS

ACCESSORIES

METAL FLASHINGS

Architectural Cladding

Rainwater Goods

Dam Busters

OUR SERVICES

ToolBox High Tack